HeVORT Berd Air Pump Anti-Vibration Mount
Description
Hi, This is my take on an anti-vibration mount for the Berd Air Pump. The main bracket can be PLA but I did it in PetG The little insert for the bottom I did in PetG, as I suspect it will get hot with the motor running. For the anti-vibration, I played around with 2,4 and 6mm thick Ninjaflex, and 4mm seems to be about right. I'm sure you could probably use just the top bracket, but as an overkill engineer, I used both. But if you only use a single top mount, you will probably be better off with the thicker top flex portion. I didn't do any fancy smancy CAD simulation analysis. Just what I thought looked OK. I liked the heatsink someone mentioned on one of the forums. So I got that, but am swapping the 5v fan out for a 12v fan to run along with the pump, which in my case is 12v. I hope you find this useful.
Statistics
Likes
9
Downloads
0