Filament Guide for MicroSwiss direct drive to use 70A TPU
Description
Designed up this Filament Guide to use TPU 70A with MicroSwiss directdrive Extruder. This is Version 2, but not tested. Version 1 was not perfectly fitting so I have cutted version 1 to most necessary. It runs with my "Micro Swiss Direct Drive Extruder with Hotend about Creality CR-10 / Ender 3 Printers" I can now print with Recreus FilaFlex UltraSoft 70 A You must decreas the PTFE Tube between extruder und hotend
Statistics
Likes
1
Downloads
0