Bosch Performance Line CX Haibike Ebike Sensor Holder
Description
I modified Oskar_B's Bosch Sensor Holder because I have an Xduro and the Fat Rear 2.8" Tire caused the magnet to hit the sensor using Oskar_B's design. In my case, the surface that the screw goes through broke off. So I used Oskar's design and added my own mounting surface that recesses the sensor a bit so the magnet clears the sensor. It works perfectly. Printing: I printed in PLA Carbon Fiber at 100% infill for strength. I printed using supports with the hollow cylinder facing down. You will need two Zip Ties to attach the sensor to the mount. I also trimmed the sensor to be flat on the end so it looks cleaner. I used side cutters to remove the extra material, see photos.
Statistics
Likes
0
Downloads
0