TPU Set for NewBeeDrone Whirligig V2
Description
This is an alternate set of TPU parts for the [NewBeeDrone Whirligig V2](https://newbeedrone.com/collections/newbeedrone-frames/products/whirligig-v2?aff=40) but may be useful in other drones too (such as the [Vivid](https://newbeedrone.com/products/newbeedrone-vivid-frame?aff=40) using a full DJI air unit), or anyone needing to mount a TBS CRSF nano on any 20x20 mount. The following are included * Antenna Mounts for [DJI Air Unit](https://newbeedrone.com/collections/all/products/dji-fpv-air-unit-module?aff=40) on NBD aluminium standoffs * Mount for [TBS M8.2 GPS](https://newbeedrone.com/collections/all/products/tbs-m8-gps-glonass?aff=40) on whirligig rear standoffs. * [TBS CRSF Nano Receiver](https://newbeedrone.com/products/tbs-crossfire-nano-rx?aff=40) Mount with 20x20 spacing, receiver held in place with supplied heat shrink * [TBS Immortal T](https://newbeedrone.com/products/tbs-crossfire-immortal-t-v2-antenna?aff=40) Mount, attached with 3mm zip ties under frame. All of the parts suited for printing in TPU without any supports.
Statistics
Likes
2
Downloads
0