Digimon Figure Cage
Description
Designed from measurements from an original. This cage model goes together the same way as the actual toy, and can be stacked with original or other 3d printed cages. I suggest gluing the Top, and Bottom cage with the lock, along with the two connector pieces in place with super glue, the top bar can just sit in place or be pulled off easily to let you put stuff in and pull stuff out. When printing at 200% scale you'll have to shim the pegs with something since it's going to be a lose fit. but same deal. just glue all of it except for the top bar and you're good to go. even at 200% scale they're still stackable. Printing: 1 of Each Part is needed for an entire cage. each has a flat spot and should have the correct orientation for printing and will not need supports. 1 complete cage should fit easily on an ender 3 at 100% scale. 200% scale will take at least 4 prints.
Statistics
Likes
3
Downloads
0