Satsana with Back Support (Ender 3 V2)
Description
Remixed the Ender 3 V2 Satsana to include a support on the back that latches onto the stock hot end plate. This remix prints just like the OG with no supports. There are two options: 1. Satsana w Back Support (No Nuts) - This requires 3 additional M3 screws that are 10 mm long (M3x10) 2. Satsana w Back Support (M3 Nuts) - This requires 3 additional M3x10mm screws and 3 M3 nuts that fit into nut slots. Make sure that your nuts are less than 6mm wide and 3 mm long. PRINTING: 0.2 mm layer height with 25 % infill. Make sure that you don't have much elephant's foot or the screws won't fit! Print each component in the given orientations; they should not require any supports. ASSEMBLY: Follow the same assembly procedure as in the original Satsana (https://www.thingiverse.com/thing:4369859) but at the end make sure to add the back support piece and their respective nuts/screws.
Statistics
Likes
11
Downloads
0