Systema PTW Battery Stopper Cap replacement
Description
Custom Systema PTW SST-009 Battery Stopper Cap replacement part. **If you like my designs and don't mind I would be happy about a beer. (Tip Designer)** Additional requirements: * O-ring => ID: 17-19mm OD: 20-22mm (this is just what I've used! Other may fit too) Printing: Layer height: 0.1 - 0.3 mm Support: yes (Touching Buildplate was enough for me) Infill: 20 % Brim: yes (not required) Material: PETG (PLA should also work but is not recommended) Assembly: After printing remove the support material add the O-ring.
Statistics
Likes
1
Downloads
0