Pegboard mount for safety glasses
Description
I got new safety glasses and needed to keep them somewhere safe. I use pegboard, so that was the perfect place. I looked at a bunch of the options available here (see below for a list) but none of them were quite what I wanted - most hold the glasses by the bridge, which might not work so well with these as they have rubber nose pads. So I created my own. The holder is quite long as these safety glasses wrap around quite a bit and wind up being pretty deep. This is designed for 1" pegboard with 1/4" holes. If you think it's just too big or don't like it for whatever reason, here are some other designs for holding safety glasses on pegboard: * https://www.thingiverse.com/thing:321835 Square pegboard, won't work for me. * https://www.thingiverse.com/thing:3494592 Holds the glasses by the bridge, might not work with my glasses. (much smaller/faster print, though!) * https://www.thingiverse.com/thing:3977583 Probably the closest to the design I came up with. Might not have been quite long enough and I don't like having the pegs run across layer lines like that. Would probably be just fine, though. * https://www.thingiverse.com/thing:4430038 Another that holds it backwards via the bridge. Simple and quick print but to me that just doesn't look "right" * https://www.thingiverse.com/thing:4191179 Different sizes but still holds the glasses "backwards". * https://www.thingiverse.com/thing:3391285 A different option that holds the glasses by the earpiece. Nice, but I wanted easier access. * https://www.thingiverse.com/thing:3516318 Just a smaller pegs version of a previous thing.
Statistics
Likes
39
Downloads
0