TCR Rear Tyre Mould
Description
I designed this up because my Daughter wanted pink tyres for her TCR cars. It is a two part mould that fits together perfectly. Place the parts together and pour silicon mould solution into the top, ideally with a syringe. I found one of the kids medicine syringes was perfect. Mix and leave to set, according to the instructions on the silicon solution.. You want to be printing these with a 0.2 nozzle and the smallest layer height you can. There is an inset, in the bottom, to put the letters TCR around the outside of the tyre. Designed for a MK3 but will fit earlier models as the inner diameter is smaller. Slightly too big for Tyco but if anyone wants a design let me know and I will adjust. I Recommend: For the Silicon: [Silicon Mould Making Kit](https://siliconmould.dragondesign.co.uk) For Colouring: [Silicon Rubber Pigment](https://siliconcolour.dragondesign.co.uk) Use the colouring pigment very sparingly otherwise the silicon does not set properly..
Statistics
Likes
5
Downloads
0