Case for RG351P
Description
For this you will need : - 18 neodymium magnets° and super glue (4mm in diameter , 1.5mm in thickness ) - 4mm foam ,very soft foam is best ( you can use thinner or thicker foam if you want (3,4,5,6mm) , just adjust the scale pourcentage as shown in the picture above) - a sharp scalpel and painter tape to cut the foam - a piece of filament for the hinge (you may need the sand the piece of filament to fit the hole) - glue or thin double sided tape (recommended) - you can use coins to make the rounded corner and the holes in the top foam Print info : - no support - horizontal expansion : -0.1mm - 0.2mm layer height (dont go higher or else the hinge wont work properly) - PLA , PETG pretty much any hard plastic would work , i recommend using an impact resistant filament magnet : search 4x1.5 magnet on AlieExpress foam : you can use Neoprene Fabric , eva foam is a bit too hard
Statistics
Likes
1
Downloads
0