Stronger V6/Dragon Hydra BMG direct drive bracket
Description
Someone posted a fortified BMG direct drive bracket to go w/ the Hydra tool changer/fan duct system. I liked the idea, but the 2 rear holes in their design did not line up properly with the channel for the inserted nut in the rear hydra base, and didn't position the extruder right over hotend (I think it was remixed from the stock creality hotend version of the hydra bmg mount). So I threw the V6/dragon BMG bracket into tinkercad, thickened up the lower platform, and beefed up the rear triangle. I was too lazy to chop the top corner off the triangle strut, I just snipped the excess off w/ side cutters. I did my best to retain the screw holes in their original locations to not run into the same issue I had with the other design. I used a drill bit the same size as the head of my M3 button head screws to create a shallow countersink of ~2-3mm so that the screws sit flush with the surface. I had to sand the bottom platform down just a bit to get my BMG to fit. Feel free to remix this if your CAD skills exceed my admittedly terrible abilities. Hope this helps someone, post a make if you print one out and it works for you!
Statistics
Likes
0
Downloads
0