KeyMod angled front grip for M4, TMC etc
Description
Wanted a front grip for my Tippmann TMC paintball marker. It's easy enough to hold, but a grip would be nice. I found this thing: https://www.thingiverse.com/thing:3206945 . I took it as template to make a keymod grip closer to the magwell, where I would hold the marker. The grip needs a length of 3 keymod holes and extends backwards by a bit. Printed fine without any supports, just ensure the mount hole side is facing down on the print bed. I've used a brim, but I do that in general to help adhesion on the first layer. Low infill is fine, the photos are with 20%. Only postprocessing needed is to remove any stray strands from the bolt holes etc. (Update 2021-09: Added more fillets, especially at the back. It was rather sharp and ate my glove's thumb covering.)
Statistics
Likes
3
Downloads
0