Picatinny Flashlight Mount - 28mm
Description
*This is an early version I'll keep working on to iron out the post processing. It works as it is now, but I'm not fully satisfied * <h3> Yet another picatinny to flashlight mount! </h3> <p>I tried to make it low profile, not too protruding or thick.</p> * **Ring diameter: 28mm **, with about ** + / - 2mm ** adjustement. It fits the widely available "XML T6" flashlight (often rebranded) * Uses ** 2 M4 screws **, and ** two full nuts ** of the same diameter. I personnaly used ** one M4 x 12mm **, and ** one M4 x 25mm **, fits like a glove * The female rail is a tight fit on my 3D printed picatinny rail. Your mileage may vary, that's what the screw is here for. * ** Infill: 100% (with PLA) **: this is really important as flexibility and toughness have been calibrated with this parameter in mind. <p>Let me know if you encounter any kind of problem or if you need another diameter. I could add quite easily a few common diameters, to make it more "universal"</p>
Statistics
Likes
14
Downloads
0