Water Jet Drive
Description
Update: New Revision (2016/09/10) On "Https://Pinshape.Com/Items/25939-3D-Printed-Water-Jet-Pump" This Water Jet Drive Has Been Developed For A Large Sized Boat. This Jet Drive Can Produce A Flow Rate Roughly 192 L/M In My Test Setup (See Below). With A Exit Velocity Of 2.1 M/S. The Aim Was To Create A High Flow Low Pressure Pump To Have A Lot Of Pushing Force. Therefore An Axial Pump Was The Best Suited Solution.... 4 Iterations Later And I Have Created An Outstanding Pump. The Only Thing That Will Be Changed Is The Prop, To A Printed Version. The Test Setup: - Using About 1 Meter Of 40Mm High Pressure Pvc Piping - 1X 90 Degree Elbow - 2X 15 Degree Bends - Overall With A Elevation Difference Of 400Mm Power Plant Using A 540 Sized Motor (3300Kv) With A 3:1 Gear Box, Driven By A 2 Cell Redback Lipo. Prop Bought A Prop From The Local Hooby Shop, The 2 Bladed Prop Has An Od Is 56Mm With A 4Mm Thread Centre. Shaft 4Mm Rigid Stainless Steel With A 8Mm Brass Housing Printed With Abs Added: Youtube Video Https://Www.Youtube.Com/Watch?V=Ifzssc7Rhs4 Check Out My Other Designs Http://Www.Thingiverse.Com/Benny90/Designs Need Something Designed Or Printed Swing Me A Message On Https://Www.Makexyz.Com/Printer/Benny90
Statistics
Likes
544
Downloads
0