DIY connector for the SFM3300 Mass Flow Meter
Description
Designed a DIY connector for the SFM3300 Mass Flow Meter so you don't need to buy an $80 connector for a $40 part. https://www.sensirion.com/en/flow-sensors/mass-flow-meters-for-high-precise-measurement-of-gases/proximal-flow-sensors-sfm3300-autoclavable-washable-or-single-use/ Just print as-is and drill out with 1/16" (1.5875mm) drilll bit to allow for a good fit for 1.5mm pogo pins. Something like this is best with 9mm depth (flat part and below, not including top part, not all pogos have this). 9mm depth will ensure the right level of compression. https://www.amazon.com/dp/B07FPKKK9W/ will require soldering and a little bit of superglue. getting the holes very perpendicular is critical
Statistics
Likes
1
Downloads
0