Microsoft Lifecam HD 3000 webcam mount for CR-10 and CR-10S
Description
A quick and dirty remix of the Microsoft Lifecam HD 3000 mount done by #patsp . I primarily use my Octoprint webcam to keep an eye out for filament feed and layer adhesion issues, so I prefer a low angle view of my bed. I also needed something that would fit within the clearance of my CR-10's Z axis support rods and not obstruct bed movement. I shortened the original model in height and length to better fit the CR-10 frame rails and bed height. I also modded the base to include two screw holes to fit the CR-10's dual frame slots using M4x12 screws and slot nuts. Prints with no supports.
Statistics
Likes
0
Downloads
0