Power Supply Box
Description
I needed for my electronics and audio projects a portable Power Supply. My focus was not about super portable device. Its simply a housing for a ATX Power Supply which provides many voltage levels. Printing: - Infill Body: 20 % - Infill Top: 20 % - Support Body: yes - Support Top: no You should rotate some file as the "steg" (jetty) for it lays flat on the printing bed. The *steg* is for secure the powersupply inside. Chose some apropriate screws with a wide head...well, maybe not too wide I guess ;) *TopHalter* will be printed *4 times* layed flat on its side. Glues this one on the "Deckel". Körper36 and Körper39 is used for a adjustable PowerSupply in addition. Körper36 is hotglued on the ventilation grille and on it the addtional PowerSupply. On top i hotglued Körper39. So its mostly protected for any short circuit. I'll add a partlist and where to get it from. In the holes an its side a wired up some Aviation GX 12 Sockets. But I realised that GX 12 is way to small. I will try to replace it with my GX 16 in some future. Maybe you noticed the notch on the Body. Its for a better grip while transport. I also changed my filament to a translucent orange and later back. (Some pictures of my print will follow)
Statistics
Likes
0
Downloads
0