Touch probe mount for voxelab aquila
Description
Designed this inspired by both https://www.thingiverse.com/thing:4747312 and https://www.thingiverse.com/thing:4826844 Idea was to have it as sturdy as possible but still allow airflow. This mount is 6mm thick at the base where it mounts to the extruder carriage. This is because I couldn't be bothered to flip out the dremel and cut the M3 screws I had at hand. So you probably want M3x8 but M3x10 should work too. Im using the latter. Print in preferred material 100% infill. BTW: If the probe end up leaning either left or right you might want to use a needle file and open one of the 2 mounting holes (for the extruder carriage) allowing it to be set straight since the people who made atleast my carriage plate used a hand drill. #Added: Updated version (v2) with the top screw hole ablong to allow for alignment.
Statistics
Likes
3
Downloads
0