Wire Grommet for 80mm Fan Cutout
Description
Made for an enclosure project where 80mm fan locations were converted into wire grommets. The inserts should be printed in PLA. They take an m3x10 screw, they should thread into the slotted insert, which can be held in place with a flat-blade screwdriver, while turning the m3 screw into it. Print 4 sets of inserts for each grommet. This could also work nicely for a PC case or other electronics casement that has an 80mm fan hole you want to run wires though. Also included is a printable template for center punching holes to cut an 80mm fan hole.
Statistics
Likes
1
Downloads
0