Dolce gusto pod dripping holder
Description
I was tired of throwing away my coffee pod full of water, and I didn't want to just put them in the kitchen sink and make it dirty. So now i put my pods on this holder, while the water is drained, and then put them to recycling. You also can put the holder on the sink to have the water directly sent to waste. No support needed. Designed to avoid bendind due to pod temperature, but prefer printing with PETG if possible. My model was printed with Geeetech PLA and is still OK after a few weeks. 20% infill should be sufficient to prevent bending. Extra tip: also works to hold boiled eggs xD
Statistics
Likes
3
Downloads
0