Systema PTW Magazine Follower Replacement for MG-017
Description
Custom Systema PTW Follower replacement part for mg-017. **If you like my designs and don't mind I would be happy about a beer. (Tip Designer)** ** Select bottom face to align the follower to the build plate (see cura image) ** Printing: Layer height: 0.1 Infill: 100 % Brim: yes (at least recommended) Material: PETG Assembly: After printing sand/polish the upper part and round the edge with sandpaper too. You can use silicon spray/oil ~100cst to polish after using sandpaper. Then put the follower into your ptw magazine slowly. Because it's 7,6mm thick it's not easy to loose it now.
Statistics
Likes
0
Downloads
0