Diablo Chair wheel stopper
Description
I have designed this wheel stopper for my Diablo X-Player chair since i couldn't find any model or project that would enclose perfectly its 65mm wheels. Also, this design avoids any possible side-swing that could potentially damage each half-wheel. It should fit any 65mm wheel for any model of chair. You can print it in whichever filament you like and with more or less any wall and infill setting. I only recommend to use at least 4-5 top and bottom layers, enough to give solid filling for the zone where the weight is applied, on the bottom of the two wheel sockets. I have printed two stops, and put 4 rubber anti-skid feets under each of them. This could a bit of a overkill, but now the chair is basically fixed on the ground! Anyway, the stoppers work perfectly even without rubber feets (on a normal stone-like floor)
Statistics
Likes
3
Downloads
0