NXP QN9090DK Coaster
Description
Designed to fit the NXP QN9090 development kit board, with a main board labeled "OM15076-3/JN5189 Carrier Main Board DK6 V3". Provides protection for the board when it's sitting on top of a pile of other hardware on your desk. Any expansion cards that go into the board should be able to freely sit on top of the case without interference. Two notes: 1) Fit is tight, but if you wiggle the board back and forth, it should slip into place. 1) The board is fully supported, meaning that this case is probably over-engineered. It takes 67 g of filament with 20% infill. If you remix to remove some of the base of the case, you should be able to reduce the filament consumption and print time.
Statistics
Likes
0
Downloads
0