Rotary Table Mount- Nema 17
Description
Nema 17 Stepper Motor (17HS24-2104S) mount for oddly shaped rotary table. Cap screws for this are M3 .5 thread 10mm long Fairly sturdy. I only needed to drill/tap 2 screws to keep it locked on tight without vibration. You may need to glue a little piece of gasket material on the motor plate to provide more stability/shock absorption but not necessary for this. I also had to turn a small groove on the rod of the rotary table for a snap ring where the handle would normally keep it in place as it is turned. Otherwise the rod will push/pull when it is turned left/right.
Statistics
Likes
1
Downloads
0