Stand for cheap blow-torch from Alliexpress.
Description
This is a stand for following blow-torch from alliexpress: https://www.aliexpress.com/item/1005002218122783.html You need to disassemble the the blow torch, unscrew the gas tank adapter and screw it on this stand using the original screws. The propane butane gas supply should be attached using standard pressure resistant hose with inner diameter 8mm and outer diameter 15mm. FreeCAD model attached in case you need to modify the dimensions (see the "Sizes" spreadsheet) Current flaws: - difficult to make air tight around the gas inlet, which causes leaks and occasional explosions. My recommendation so far is to smooth the printing layers on the inlet by using epoxy glue. - requires sufficient pressure and flow to cool down the blow-torch base, otherwise the it heats up and softens/melts the stand, which in turn causes leaks and occasional explosions. In my case the explosions were prevented once I removed the reduction valve on the gas tank. So use common sense before you print/start using this.
Statistics
Likes
2
Downloads
0