ADXL345 Taralu Modular X Carriage Mount with BLTouch on MGN12
Description
I've completely upgraded my TEVO Tarantula and now use Klipper firmware on an SKR 2 board. I wanted to be able to use the Adafruit ADXL345 Accelerometer for resonance tuning without needing to print a new tuning tower every time I change anything on my drive systems. I am also running MGN12 linear rails that required me to cut the Taralu E3D V6 mount to flip over to the other side of the X carriage to be able to get the print head under the level of the X gantry rail. Therefore, this BLTouch mount is a total of 20mm from the top of the mount area to the bottom where the BLTouch actually mounts to it. This will be lower than most people are able to use if they are not running the same Taralu and MGN12 combo. Print this at 100% infill and I used .2 layer height, but it should print .1 just fine. The offset on this is X=+34 Y=+2 I know that it's an edge case, but I would have loved to just download and print if I was able to, so maybe someone else will get some use out of this as well. :)
Statistics
Likes
0
Downloads
0