Camera Mount for Creality Tent Enclosure
Description
Yet another camera mount, because the world needed more. I have a Creality 3D printer [tent style enclosure](https://www.amazon.co.uk/gp/product/B087LXWM7Q/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1) with a pipework frame. It made sense to have a camera mount that could clamp to the frame and provide an easily adjustable view. The design is reasonably simple and I include the blend file so you can adjust to your particular setup if required. ----- __arm1__ This part latches onto the pipe frame of the tent along with the __clamp__. I went for 40% infill (for strength) and a brim to print this as without the brim the curve end had adhesion problems on my Ender 3. You will also need support for the ends. __arm2__ Print this vertical with the cup of the ball joint on the build plate. Again, 40% infill and a brim is probably best. __clamp__ Print on it's side, 40% infill. No support or adhesion stuff needed. __balljoint__ Print with the flat part of the ball on the build plate. 40% infill, brim if you like but I didn't need one. __mount__ Print flat, pins upward. No support, may need a brim due to the thin nature of the arms. The pins on the example are 2mm diameter, slightly tapered, set in a 3.4cm square. This matches the camera I [have](https://www.amazon.co.uk/gp/product/B07G9VLPZH/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1). If your camera is different you will need to adjust before printing. -------- Additionally you will need 1 screw+bolt to hold the __clamp__ onto __arm1__. The one I had in the drawer was 2.5mm for the threaded shaft so the hole in the parts is 3mm to allow easy insertion. The blend file can be used to alter this if required.
Statistics
Likes
0
Downloads
0