Ender 3 Max Power Supply Bracket - Dual Z Axis
Description
I upgraded to the second dual Z screw on my Ender 3 Max and needed to relocate the Power Supply so I made this bracket. Make sure you ground the power supply! Printing: Infill - 30%-100% (I like 100% for structural components) Supports - No Orientation: Reference isometric image for orientation in slicer to avoid using supports. Rafts can be helpful on this unless you have great adhesion - I've tried both with/without just fine. Part will snap onto frame at the rear right side of printer (if you're looking at it from the front). Message me if you'd like to collaborate on improvements. The model is very rough since I reverse engineered the interface mate by caliper.
Statistics
Likes
25
Downloads
0