Meanwell power supply relocation
Description
After watching a Teaching Tech video about dual Z I printed the one Michael highlighted in his video. It works, BUT I did not like the plug hanging off the back. I prefer to keep the plug and switch on the side. You will need (4) M4 x 20mm lg bolts and (4) t nuts. I posted this as a remix but it was completely redone from the ground up. I found the base where the (4) bolts are to be to skinny and my bolts were bottoming out on the extrusion- so I added a little bit more to it. I also altered a little bit of the geometry here and there. The obvious diffrence was putting the dog house on the right side.
Statistics
Likes
15
Downloads
0