V100 suspension arms
Description
These are version 2.0. They are redesigned to be stronger. Make sure to print them vertically the way they are so the pivot eyes have the maximum strength possible. These are upper control arms for the Losi/Vaterra V100 touring car. The front arms use M3x20 set screws and 3x3 aluminum ball rod ends with a 5mm O.D. shank. The rear arms use M4x20 set screws. You can always cut lengths of all thread if you don't have the set screws required. The ball ends are available on Amazon or eBay. Be sure to drill the pivots on the arms with a 3mm drill bit.
Statistics
Likes
3
Downloads
0