Barbell Holder
Description
I made this to keep barbells stationary and slightly raised off the work-surface during cleaning. The smaller half-circle holds a 28mm barbell and the outer half-circle will hold a standard 50mm sleeve, giving you the ability to clean the entirety of the shaft or sleeves without the holder being in the way. Printing: Material: PLA Standard Quality in Ultimaker Cura (0.2mm) Infill Density: 5% Infill Pattern: Cubic Import into Ultimaker Cura and lay flat on the side or print it standing up straight; either works.
Statistics
Likes
2
Downloads
0