TacClip
Description
"The "TacClip" is geared towards law enforcement, private security, and military personnel. All too often, people within these professions wear a duty belt during their shift and most phone cases with belt clips will not work with a duty belt. While they can fit over the top of the duty belt, the phone case’s belt clip is typically forced into an open position, allowing the phone (and cradle) to easily come off of the duty belt. This is where the TacClip comes into play. The TacClip slides onto your duty belt and allows a platform for attaching your phone’s cradle (belt clip). It can also be used with radios that have an attached belt clip." -- We typically print these with NylonX material, but I have printed these in PLA and PC without issue. These are the settings that I use on our Raise3D N2 Plus printer with the ideaMaker software (your mileage may vary). Layer height: 0.2mm Shells: 2.0 Infill: Adaptive infill, 40-60% Infill Pattern: Gyroid
Statistics
Likes
6
Downloads
0