Mini B 2.0 wing mount
Description
Edit - V2 is designed 5mm longer and cutout so you can put a washer and nut on the wing screws. I also gave this 3* of upward angle. Print with TPU for less breakage. Print this wing with 20-30% infill for some flexibility. I used two 15mm tapered screws so it stays centered in the tower holes. I found Long screws help with holding the wing mount on but also gives a little with any impact. Not a perfect design but it should be fine for race scenarios, just print extra's and never be without a wing mount. Stronger than you think and able to take an impact.
Statistics
Likes
8
Downloads
0