Creality Ender 6 LGX mount (Not finished) updated cooling duct coming very soon
Description
Screw the bottom ptfe bracket into the the mosquito and then slide it into place. Add the two front bracket screws and tighten. Insert two m3-8 into the side and two m3-6 into the bottom of the LGX and finally line it up to the Ender 6 and put back all but the one of the original mounting bracket screws. Cooling duct is untested and needs to be fixed. (its also ugly) this also requires the Y endstop to be flipped to fit. **THIS WILL FIT AND RUN WITH AN ESTEP START GCODE BUT IT WILL OVERHEAT UNLESS YOU ADJUST THE VFREFS**
Statistics
Likes
1
Downloads
0