Mi Band 5 wrist band
Description
Just a simple alternative to the classic xiomi mi band bracelet. This will not break after a couple of months as the original... INSTRUCTIONS Part1 is the main piece. It is open at one end to allow some deformation to insert the whatch. Part2 is the chain. These pices are held together using small 1.75 filament pieces. Part4-5 is the open-close bit If you like it you could use some M2 bolts to hold the various pieces together instead of filament pieces. PRINTING I used my resin printer but this should be printable on any FDM machine with a small nozzle (0.4mm or smaller). If needed you can drill out the holes to get a better fit. Hope you like it!! If so please leave a like - Edit 26/08/2021: Designed a simple latch to open and close the chain easily. (Part 4 and Part5)
Statistics
Likes
24
Downloads
0