Replacement Hood-Prop Foot
Description
If you have used the typical telescopic hood prop for some time, you likely end up with the small-end of the prop wearing it's way through the rubber foot. This replaces it with a more robust design, and you can put a washer in there to improve longevity, especially if you use a softer material. The end of the prop just cuts it's way through soft rubber and TPU like a die -cutter, so a washer or anything that increases surface contact helps. I used semiflex, it isn't really squishy but is quite tough and durable. Print as is with the ridges up, no supports, and use a brim if you'd like.
Statistics
Likes
1
Downloads
0