WLToys 104001 Kick Plate w Bumper for 5mm & 2mm carbon chassis
Description
This is designed to restore the factory kick/castor to the WLToys 104001 4wd buggy if you are upgrading to either the 5mm thick or 2mm thick carbon fiber chassis kit. The stock aluminum pan has 5 degrees of “kick” which combined with the castor built into the front steering blocks. Swapping the aluminum pan for the available carbon chassis’ results in a loss of total castor. This wedge corrects that and adds a small bumper to protect the front of the carbon chassis from impacts that could split the carbon chassis and result in delaminating. I recommend printing this part with a Wall Line Count of 6 or more and an Infill Density of 50% or higher for maximum strength. With a Wall Line Count of 6 or more, the screw holes will be attached to the walls and the bumper will be solid. You can watch all of my videos on the 104001 at this link. https://www.youtube.com/watch?v=RNKN0IYBDG8&list=PLWi1J2KoLS70A2-LdYiCIedt04a3nmXm1 Here is the link to the specific video where I do the 5mm chassis upgrade on my 104001. https://www.youtube.com/watch?v=w3nDG0x7fq0&list=PLWi1J2KoLS70A2-LdYiCIedt04a3nmXm1&index=9 I’ve also designed a set of parts to allow a standard shorty hard pack lipo to be used with this car. They are here on Thingiverse.
Statistics
Likes
5
Downloads
0