Universal Projector Leveller
Description
Universal Projector Leveller Do You Have A Problem With Levelling Your Projector? Or Maybe Your Projector Doesn'T Have Any Levelling Features? Super Easy Tool For Properly Levelling Your Projector. I'M Using It With Upside Down Projector (Cause Of That My Screen Is Lower Than Projector). Setup: Print 4X Part1 And 4X Part2. Stl Files Are For Plywood 6Mm Tick, Threaded Rod 6Mm And M6 Nuts. (In The Bottom Of Part2 You Have To Use Nuts With Rubber On The End. That Will Cure The Unscrew Effect While Levelling.) Plywood Should Be Size Of Your Projector. I Cut Threaded Rod To 2X 10Cm And 2X 20Cm Long Parts. 3-4 Pcs. M6 Nuts For One Corner Files: Use "_Remote" Files In Case Of Ir Remote Receiver In Corner Of Projector. You Can Also Customise Parts In Solidworks By .Sldprt Files. Why? Internal Optics In Lots Of Projectors Are Skewed Up From Horizontal Position, In Case Of Ordinary Usage Of The Projector From Table Or Ceiling. If Projector Is Not On The Table And Is Not Screwed To The Ceiling But Little Higher Than Projector Screen, For Best Image You Must Lay It Upside Down On Flat Surface. In General, Even With Normal Usage Of Projector Someone May Need This Solution Due To The Lack Of Levelling Feature In Device.
Statistics
Likes
1419
Downloads
0