RAY GUN based on LEGO Ray gun
Description
Here are a bunch of versions 1: Whole version - print with supports 2: Half/Half version - should print with no supports 3: All The Parts version - some yes, but most no, supports use your best judgement Change it, leave it the same, do what you like, have fun with it. Printing: ALL THE PARTS version. The alignment plug is beveled and not beveled, goes between the barrel and body. The hand grip sets into it insets. The site sets into its slot. The side donuts are beveled and not beveled and nest in the donut holes on the side of the body. The rings snap into place on the barrel. very tight make sure and assemble large -medium - small. Glue as needed. Pew Pew Pew
Statistics
Likes
2
Downloads
0