Viticulture Card Holder Split
Description
I wanted to print the Viticulture insert of deludik but the build volume on my Ender 3 v2 was not big enough for the card holder. So I sliced it in two parts that can be glued together. Maybe it is useful for other makers. IMPORTANT: Fusion360 spit out the models scaled up x10. So you need to shrink them to 10% (uniform) in Cura or your slicer of choice. I can't fix it myself atm. A completely vertical slice was not possible due to the angled card dividers so I chose 30° to make the overhangs easy to print. It printed easily on 0.3mm layer height with 10% infill. It was glued together with 2 component adhesive. My gluing looks a bit messy but if are more careful the seam shouldn't stand out much. One last tip: Although I never had problems with adhesion before these model slightly curled up on one side. I'm guessing it happen because all dividers are angled and pull the model to one side while cooling. So to get sharp corners you can use a simple brim.
Statistics
Likes
0
Downloads
0