Frankenstein - BLTouch rear mount - Anet A6
Description
This was a fast hack to mount the BLTouch / 3DTouch sensor in the rear of the Frankenstein. I did not want the sensor in the front for nicer look.. but there are some problems: - You can not longer use the full build plate, as the mount hits the frame - You can not longer use the full building height, as the mount hits the frame - The printers dimensions can be confusing sometimes All of this is mitigated via configuration and the printer can be used safely, but you loose some buildspace. It was just a proof of concept and it's working so far. --------------- Marlin - `Configuration.h` ```c // ANET A& with BLTouch/3D-Touch mounted in rear of Frankenstein #define NOZZLE_TO_PROBE_OFFSET { 0, 62, -1.15 } #define PROBING_MARGIN 0 // ANET A6 Frankenstein #define X_BED_SIZE 205 #define Y_BED_SIZE 200 #define X_MIN_POS 7 #define X_MAX_POS 212 #define Y_MIN_POS -6 #define Y_MAX_POS 194 #define Z_MIN_POS 0 #define Z_MAX_POS 187 #if ENABLED(Z_SAFE_HOMING) // Anet A6 with new X-Axis and defined X_HOME_POS -7, Y_HOME_POS -6 #define Z_SAFE_HOMING_X_POINT 112 // X point for Z homing #define Z_SAFE_HOMING_Y_POINT 110 // Y point for Z homing (centered to probe) #endif ``` -------------- It is mounted in the rear by using the two screws that connect the fan duct with the carriage.
Statistics
Likes
0
Downloads
0