Boba Fett blaster pistol (Mandalorian Season 2)
Description
Boba Fett's blaster pistol from Season 2 of The Mandalorian. Based off a Sedgley Mark 5 signal pistol. Designed to house a switch and LED for a working trigger. Handle will require supports and a good amount of cleanup, everything else prints easily. I used my resin printer for the rear screw, grip ring, and button pieces. The rear screw actually threads into the handle to provide a little hole to help guide the switch into place. Tolerances are pretty tight so sanding may be required for fitment. The middle is designed to house 8 magnets for easy access to the electronics but if you're not interested in doing that, just print out 4 of the post pieces and glue the two halves together. The scope takes a single LED - trim the leads down to fit it in the holder. This one isn't designed to turn on, just for looks. Please share your builds of this, I'd love to see them! **THIS ITEM IS NOT FOR COMMERCIAL USE** Parts used: Switch (1): https://www.ebay.com/itm/353226051346 *Take the cap off the switch before mounting* Magnets (8): https://www.kjmagnetics.com/proddetail.asp?prod=D42 LEDs (2): https://www.amazon.com/EDGELEC-Diffused-Resistors-Included-Emitting/dp/B077X95F7C/ref=sr_1_6?dchild=1&keywords=red+led&qid=1631138979&sr=8-6 You'll have to use a resistor for the LED and some kind of battery, I plan to use a button cell with a makeshift holder.
Statistics
Likes
101
Downloads
0