Creality CR10V2 Direct Drive Bracket
Description
This is my design of a bracket to convert the Creality CR10V2 into a Direct Drive setup. Move the extruder to this bracket, extend the wires and install 2 bolts/nuts to secure it to the carriage. If you have a BTT Filament Sensor, I also have a version of the bracket to secure that. As seen in my assembly picture, I've drilled and tapped a 6mm hole in the extruder arm to insert the bowden tube that comes with the BTT sensor. Printing: Printing extruder mounting face down uses less filament due to not needing much supports, but the strength is reduced in the rear clamp area that curves behind/below the carriage. Printing on its side gets the best strength. On the simplified bracket, I've also made the clamp just a small lip that keeps the back of the bracket down. It is enough as this area doesn't see much forces and only keeps the bracket from moving about during retractions.
Statistics
Likes
3
Downloads
0