iPad 2/3 Car Seat Holder
Description
I went through a bunch of models that are not found anything. I had no choice but to model my own model for myself. Here, I decided to share with our community. Printing: Infill: 40-100% Sopports: No Rafts: No Layer height: 0.2 Print high model is recommended to do 20-25 mm wide brim, so that the model is not blown off at higher layers. It is better to print the hooks themselves with the maximum contact area, but here you cannot do without supports. Here the border is recommended to be at least 10 mm.
Statistics
Likes
0
Downloads
0