Filament guide with dust filter (with bearing)

Description

I was inspired by other projects of filament guiders and filters and tried to combine them, that's how the guider with ball bearing and with built in filter was created :). This allows the filament to lay down nicely when the head moves up and down, and also makes retraction easier. To install, simply refer to the photos, screw the bearing onto the filter, and then push it into the mount. Use a properly cut sponge for filtration. <h2><strong>Additional parts needed:</strong></h2> 2 x M3x12 (or more) screw 2 x M3 Nut 1 x M3 Bolt Washer 1 x M3 T-nut 1 x 623ZZ bearing 1 x Sponge :) And you can use threadlocker <h2><strong>My settings for printing of individual parts:</strong></h2> Mount - Resolution 0.16mm - Shells 2 - Infil 25% Filter - Resoulution 0.12mm - Shells 2 - Infil 15% Filter Cap - Resoulution 0.12mm - Shells 2 - Infil 100% If you make this project share it in the comments or "Post a make". I will be happy if it works for you :). You can also "buy me a few grams of filament" through a tip ;). <a href="https://bit.ly/3nUEKOZ">  </a>

Statistics

Category

Tags