Ender 3 Pro all-in-one electronics enclosure
Description
This is an all-in-one enclosure originally designed by demitrix. It holds the power supply, control board (Creality, SKR Mini, or other dimensionally equivalent), raspberry pi, buck converters, and some other electronics all in the same unit. Changes made: - Main enclosure body cut in half for easier printing - The "bottom level" plate is adjusted for the TH3D Studio EZABL control board instead of "CSI to HDMI" board. - Hole for data cables moved to side to allow for shorter cables and let you push the enclosure back - Enclosure (halves) now bolt to power supply, as well as each other and rear - Fixed a "half-blind hole" issue in rear plate of enclosure - Added nut pockets to "Display Mount", expanded it to use two bolts in PS (this is an update added 30 Sept 2021) You will also need the "top layer" plate from the original design since it hasn't changed. You need (4) M4 x 8 screws to bolt the enclosure to the PS. 6mm long screws will work if that's all you have, but I wouldn't go much longer than 8. I used (4) M3 x 6 to pin the two enclosure halves together and (4) M3 x 8 screws to pin the center section to the rear plate. The M3 screws for the external parts are essentially alignment pins, no need to put any real torque on them. Screw them down so that the head touches and that's it. So long as they don't slip out on their own, you're golden. Assembly is similar to the original design; start at the rear and work forward. With the enclosure being chopped, you can temporarily mount the front half with display board to test/debug wiring issues. Big thanks for [demitrix](https://www.thingiverse.com/demitrix/designs) for the original STEP files, that made this a whole lot easier.
Statistics
Likes
90
Downloads
0