Orqa FPV Shark Byte Swivel Mount
Description
A bracket to allow swivel mounting of the Shark Byte receiver on the Orqa FPV One. I tried the surface mounts but wanted to be able to remove and here in Arizona Velcro surface fasteners tend to unglue themselves. I also like being able to adjust the angle. This is printed in Carbon Filled PLA as it meant I didn't need to worry about shrinkage but you may want something more rugged since it will be glued on. If you use a material with shrinkage remember to add that as tolerances are tight. I used 3 external layers so there isn't much infill. Uses an M3x16 bolt which you can tighten slightly so that it stays where positioned
Statistics
Likes
3
Downloads
0