Filament guide for PETPull-2
Description
**Update 24.09.2021** This design operate properly only up to ~20m filament length as reported by community. This is enough for bottles up to 9 litters but not suitable for 30 litters kegs. **Update 18.09.2021** New version of base Spindle_bas_V2 with wide mount wholes to adjust position at mount time. - - - #### Description: This is filament guide for [PetPull-2](https://www.thingiverse.com/thing:4900782) The design inspired by Artur(@sangalt) idea one from [PETPull(Official Group)](https://t.me/PETPullGroup) #### Additional materials: * 6 mm smooth steel rod (60 mm) x1 * M6 DIN125 washer x2 * 4.2x16 DIN968 nail screw to mount x2 #### Assembly: * Clean roller whole by 6 mm drill bit until it will rotate on rod without force * Add some grease to rod and washers * Add washer on rod at each side of roller * Mount base inside PetPull-2 machine reducer as close as possible to front (where filament in) and to side opposite to gears (see photos). But you can experiment with base position. * Put rod to notches in base with significant force until click P.S. Roller part design files names spindel :)
Statistics
Likes
5
Downloads
0