Screwless RGB2HDMI Case
Description
I wanted a case to protect my RGB2HDMI setup, but was too lazy to go to the hardware store for the M2.5 machine screws and nuts, so I spent hours designing a screw-free case that clicks together. The little nubs on the ends of the lid will probably just print as small bumps (and on the rim of the case, there are small indents, same story), this is fine, it's purely to make the lid "snap" on a little bit. My 3D model shows 4 of the spacers, but realistically the board-to-board connection is plenty to support that edge, so I only printed 2 and install them at the edge nearest the buttons (see photos). This is my first submission. Hope it helps somebody.
Statistics
Likes
1
Downloads
0