HGLRC Wind5 Racing Prints HD Sharkbyte
Description
HGLRC WIND5 5 INCH FPV RACE DRONE BITS Top Plate Fin For Flip Over after Crash Camera Pod - FPV Camera 19mm Mount Rear Trunk Designed To Fit - Emax Nano Antenna - Panasonic 50v HF1000 - XT60 If XT60 doesnt match to your needs Mirror the design in 3D printing cutter I used Sain Smart TPU, with tree supports with the camera mount printed on its side. -Material Printing Temps May vary on Printer- Head Temp 215C Bed Temp 45C -Print Speeds- Walls,Bottom,Top, Supports -Speed- 32mm/s Infill, Support infill -Speed - 40mm/s. Inflill Pattern - Lines Infill Overlap percentage - 30.0% Build Plate Adhesion Type - Brim Brim Width - 8.0mm Brim Only On Outside
Statistics
Likes
2
Downloads
0